SpielByWeb

TwoforTwo · Joined: 26 Oct 20 Posts: 23

I have a Vapedroid from S-body with a defective daughter Board.

S-body disfigured poor DNA Board with terrible soldering, 2 daughter boards

and removing the up/down/power buttons. The "fire" and "down" buttons had a bridge.

I would like to know if bridges are needed to use external buttons when taking off

on-Board buttons.

The chip has been cleaned and is ready to be installed in the proper mod.
[img]https://forum.evolvapor.com/applications/core/interface/file/index.php?file=/monthly_2018_03/IMG_20180331_172323.thumb.jpg.31a749e979dd40a91071a2db65cb7e8a.jpg[/img]

JanHam · Joined: 09 Aug 20 Posts: 160

Are you sure that this can be fixed?

smormad · Joined: 17 Jun 20 Posts: 26

Hi
It looks scary:) but you can always fix everything, that's what my grandfather said. By the way, you can use another way to make a printed circuit board and not spend time. Now I have a job my brother and I, we are based on the repair of houses we also work with printed circuit boards often, such as smart home system. I also did the same thing at my home. To be honest this is the most difficult part we use pcb design software , this service does everything and we install. By the way, there was an order where a person wanted to open the garage two minutes before his arrival, there was a lot of trouble with this small remote, but the design is simple... I suggest you take a look, it might help you.